TK11 R5
The Fenix TK (Tank) series features a powerful, solid, durable, and waterproof design intended for rugged outdoor and military use. The TK11 uses 18650 Li-ion or two CR123A batteries and maintains excellent constant brightness with two output modes: General mode, which can last for a whole night and can be used for general illumination, and Turbo mode, which can be used whenever high-powered light is needed - search and rescue, long-range target identification, etc.
Features
Cree XP-G LED(R5) with lifespan of 50,000 hours
Two modes of output, selected by turning the bezel (Patented):
-Turbo Mode: 285 Lumens, 2.7 hours (18650 Li-ion)
-General Mode: Constant 60 Lumens, 14 hours (18650 Li-ion)
Max beam length: 200 meters
Digitally regulated output - maintains constant brightness
Uses 18650 Li-ion or two 3V CR123A lithium batteries
Anti-reverse protection
135mm (Length) x 25.4mm(Diameter) x 34mm(Head)
152-gram weight (excluding batteries)
Made of durable aircraft-grade aluminum
Premium Type III hard-anodized anti-abrasive finish
Waterproof to IPX-8 Standard
Toughened ultra-clear glass lens with anti-reflective coating
Tactical tailcap switch with momentary-on function
Anti-roll, slip-resistant body design
Included accessories: one holster, lanyard, rubber switch boot and two spare o-rings
Note:The above-mentioned parameters are approximate and may vary between flashlights, batteries, and environments
Operation
Normal Operation:
Depress the pushbutton switch halfway to momentarily activate the light. Depress the push button completely to turn on the flashlight, the light will stay on until the pushbutton is depressed to turn off.
Output Selection: Screw the head clockwise for Turbo Mode, unscrew the head for half turn for General Mode
Battery Replacement
Unscrew the tail cap to insert the batteries with the anode side (+) toward the lights head, screw the tail cap back on to test.
Usage and Maintenance
The thread of the tail is protected by a hard anodizing layer which is wear resistant, so please replace the battery by opening the tail. In order to reduce abrasion, please screw the head only when you adjust the output, abnormal abrasion will cause performance declining or even problems to the flashlight.
18650 Li-ion rechargeable battery is not civil battery, use the 18650 rechargeable battery with protection circuit, or the battery may have the danger to burn or explode.
Please don't disassemble the sealed head, doing so can cause damage to the flashlight and will void the warranty.
Please use batteries of high quality, if the flashlight is not to be used for an extended period , remove the batteries, or the flashlight could be damaged by electrolyte leakage or battery explosion.
Please replace the O-ring if they are damaged after using for a long time and regularly lubricant the o-rings as to not erode the rubber. Doing so will keep the flashlight properly sealed against water.
Please clean the contacts of your light from time to time, especially if the light flickers or doesn't light up. There may be several reasons for a flickering or not working light:
Reason A: The battery needs replacing.
Solution: Replace batteries (Please confirm the correct installation of anode and cathode).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol soaked cotton swab.
If the above methods don't work, please contact the distributors and refer to the warranty policy.
Package Includes:
Fenix TK11(XP-G R5 Cree Edition) LED Flashlight - Black Finish
Belt Pouch
Lanyard
Extra O-Rings
Spare tailcap boot
includes 2 primary cr123 a batteries
|
You are now located at: J2ledflashlight 
Home
