Located in Toronto, Ontario, Canada

       Free Shipping to              Canada only

No GST / HST for our

Canadian customers

View Cart

Fenix LD22 - 190 Lumens  

Fenix LD22 - The All -round Champion in outdoor Lighting, 190 lumens flashlight with side mode switch powered by two AA batteries.

The Fenix Model LD22 provides reliable illumination in a wide variety of applications.  With four brightness levels and two flashing modes, LD22 employs a side mode switch for quick changes.  Powered by readily-available AA batteries, this compact flashlight showcases the durability and power management for which Fenix is recognized around the world.

 647-989-6009

Features:

◎ Cree XP-G (R5) LED with a life span of 50,000 hours

◎ Uses two 1.5V AA (Ni-MH, Alkaline ) batteries

◎ 156 mm (Length) x 21.5 mm ( Diameter )

◎ 60-gram weight (excluding batteries and body clip)

◎ Digitally regulated output maintains constant brightness

◎ Reverse polarity protection guards against improper battery installation

◎ Anti-roll, slip-resistant body design

◎ Push-button tail cap switch with momentary-on function

◎ Side mode switch in the front, fast and convenient

◎ Made of durable aircraft-grade aluminum

◎ Premium Type III hard-anodized anti-abrasive finish

◎ Toughened ultra-clear glass lens with anti-reflective coating

   Notice: The above-mentioned parameters (lab-tested with 2500 mAh Lithium     battery) are approximate and may vary between flashlights, batteries and     environments.

Operation Instruction

Turning on/off

Press the tail cap switch lightly to momentarily activate the flashlight.  Press the tail cap switch completely to turn on the flashlight and lock it. Another press will turn it off.

Mode selection

A single press on the side mode switch allows switching between Turbo→Low→Mid→High→brightness  levels;

Press and hold the side mode switch for about one second to enter into Strobe mode.

Press and hold the side mode switch for about three seconds to enter into SOS mode.

While in Strobe or SOS mode, a single press on the side mode switch returns you to the non-flashing mode.

LD22 memorizes the brightness level while in the general mode. When turned off and then on, the flashlight automatically enters the general (non-flashing) mode.

Battery Specifications

Type                   Dimensions    Nominal voltage         Usability 　

Ni-MH battery         AA               1.2V                  Recommended

Alkaline battery       AA               1.5V                     Usable

Non-rechargeable

Battery (Lithium)      AA              1.5V                     Usable

Rechargeable

Battery(Li-ion)        14500           3.7V                    Banned

Battery Replacement

Unscrew the tail cap to put in the battery with the anode side (+) toward the light head.  Simply screw the tail cap back on to test.

      Usage and Maintenance

◎  Please don't disassemble the

      sealed head as doing so can cause       damage to the flashlight and will       void the warranty.  

◎  To get the most from this LD22,       Fenix recommends using high -       performance Ni-MH  rechargeable       batteries. Alkaline batteries will       reduce runtimes significantly.

◎   High-quality batteries are        essential and must be removed        when the flashlight will not be        used for an extended period of        time.  As with other performance        electronics, LD22 can be damaged        by battery leakage and the        potential for battery explosion.

◎Due to the momentary-on tactical     switch, the flashlight can be     activated when     stored,transported or placed in a     pocket. Unscrew the tail cap one-     half turn to avoid unwanted     operation.

◎Long-term use can result in O-ring    wear. To maintain a proper water    seal, replace the ring with an    approved spare.

◎ Periodic cleaning of the battery      contacts improves the flashlight’s      performance as dirty contacts      may cause the LD22 to flicker,      shine intermittently or even fail to      illuminate for the following      reasons:

Reason A: The battery needs replacing.

Solution : Replace batteries (Please confirm the correct installation of anode and cathode).

Reason B: The threads, PCB board contact or other contacts are dirty.

Solution : Clean the contact points with a cotton swab soaked in rubbing alcohol.

If the above methods don't work, please refer to the warranty policy before contacting your authorized distributor.

Warning

LD22 is a high-intensity lighting device and capable of causing eye damage to the user or others so please avoid shining the light directly into anyone’s eyes.

ACCESSORIES :

Holster, body clip, lanyard and spare o-ring  

Don’t forget your Fenix accessories .

Fenix LD22 in a holster